Using the eye dropper tool with making hard mask

We will share our short tips/tricks here and you can too.
Post Reply
John D.
Posts: 5
Joined: Tue Dec 08, 2020 7:51 pm

Using the eye dropper tool with making hard mask

Post by John D. »

This tip may have been covered in Joels training. When making hard mask and using the rectangular tool to subtract areas from the mask , I use the eye dropper tool to see if the area to be subtracted is completely black. I check the area and determine the areas that are 99% black and subtract it. I have found I was subtraction areas I thought were black but we not. This is also helpful in not over applying the "amplify" feature to the mask area leading to possible bad edges.
Post Reply